Specification

Condition: 100% brand new

Item: 630-465

Voltage: 12V DC

Model: EIM PLUS

【Over-speed Signal (EIM Plus only) 】: The EIM Plus monitors the speed signal from the magnetic pick-up. If the engine speed rises above a certain pre-setable value, this engine interface module sends a zero volt signal to the generator set control panel to activate the over-speed fault circuitry

【Individual Protection】: Our DC 12V engine interface module is a sealed, engine mounted module that provides switching relays for the Starter Motor Solenoid, Glow Plug and Fuel Solenoid. Each of these circuits is protected with individual fuses mounted in the module. Individual LED's illuminate when each circuit is energised

【EMI Plus】: There are two versions of the engine interface module available: EIM Basic: The EIM is utilised in conjunction with control panels equipped with over-speed shutdown. EIM Plus: The EIM plus is used in conjunction with control panels not equipped with over-speed shutdown

【Over-speed Set Point】: The over-speed Set Point is factory set at 55 Hz for 50 Hz sets and 66 Hz for 60 Hz sets. This can be adjusted using the adjustment screw accessed through the hole beside the over-speed Set-up LED

【Adjustable Screw】: While the engine is running at the rated speed (1500 rpm for 50 Hz or 1800rpm for 60 Hz) the adjustment screw should be adjusted until the Over-speed Set-up LED just goes out. This sets the over-speed value at 10% above the speed at which the generator set is operating